澳洲幸运10龙虎和走势图

  • Custom molded part; multi-faceted caps and plugs

澳洲幸运10现场开奖直播

This is a unique custom designed molded and die cut masking system; in fact, it's similar to the custom mask found here - and was for the same customer. The red part is a custom molded piece; the orange donuts are custom die cut from silicone sheeting. The part is an aircraft die cast piece, and had some important surfaces requiring no coating. The customer contacted Viadon and we designed a custom masking solution for them which increased productivity and masked the part effectively.

First, the red piece. Though it looks like a table, that's really the "upside down" orientation. The "bottom of the table-top" - so to speak - covered one side of the metal part, which had a central round section protruding from it, as can be discerned from the bulge on the "table-top". But the customer also needed to mask the four holes around the corners of the part. So rather than putting the part down and inserting four separate pull plugs, Viadon designed integrated pull plugs right into that "table top" (which gives it that look of a table).
But these are no ordinary SPP silicone pull plugs.

On the opposite side of the metal piece were four areas where washers had to be placed in final assembly. There could not be any coating on these surfaces.  But unlike the blue molded part with integrated one-piece die cut mask, for this second part the customer asked for individual die cuts on each corner, as they felt for this part it would work better for both the coating process (powder coating) and allow them to have a lower cost option for the washer-masked sections, allowing a lower cost for replacement after coating built up on them.

But to keep these orange silicone die cuts in place, the "pull plug" sections of the red molded piece were made with a radius-tapered section.  This was designed precisely so that they would not only pull all the way through the orange die cuts, but then "snap back" and create downward pressure ON the orange mask, holding it firmly in place.

Satisfied customer! Viadon delivered an updated version of an already-successful solution for this complicated masking problem, improving coating results and maintaining customer efficiency and satisfaction.

SO GOOD, EVEN OUR COMPETITORS LIKED IT

A few months after we delivered this part to our customer, the same exact part and design showed up in some sales literature from one of our competitors! Our customer must have shown how well the part worked, and our competitor then literally took the part and added it to their sales literature - and passed it off as if they had made it themselves! A testament to our creativity that they thought so highly of our design, though it doesn't speak well of that competitor's sales practices...

澳洲10官方直播 澳洲幸运8号码 SG赛车平台注册 澳洲5软件下载 SG赛车网